Home >> Car Lifts >> Two Post Auto Lifts >> CL10series >> Specifications

CL10V3-DPC-QC Two Post Lift » Specifications


View Specifications for other CL10V3-DPC-QC models:
CL10V3 – Standard Models
CL10V3-DPC – Dual Pendant Control Models
CL10V3-QC – Quick Cycle Models


Model
CL10V3-DPC-QC CL10V3-2-DPC-QC CL10V3-3-DPC-QC

Lift Capacity*

10,000 lbs. (4535kg)
A Rise Height1
74-1/8" (1908mm)
B Column Height
11' 8"
(3556mm)
13' 8"
(4166mm)
14' 8"
(4470mm)
C Cylinder Overall
(Full Stroke)
11' 11" (3632mm)
D Adjustable Width Overall
11' 6-1/2" / 11' 11"
(3518mm / 3632mm)
E Drive-Thru Clearance2
100" / 104-1/2"
(2540mm / 2654mm)
F Floor to Overhead Switch2
134-1/2"
(3416mm)
158-1/2"
(4026mm)
170-1/2"
(4331mm)
G Front Arm Reach (Min/Max)
Min. 19-13/16" / Max. 42"
(956mm / 1524mm)
H Rear Arm Reach (Min/Max)
Min. 37-5/8" / Max. 60"
(956mm / 1524mm)
I Screw Pad Height3
Min. 3-7/8" / Max. 6-1/8"
(98mm / 156mm)
J Inside Columns2
110" / 114-1/2"
(2794mm / 2908mm)
K Low Lock Height
12" (305mm)
Motor
3HP
Voltage
208v - 230v (Single Phase Standard)4
Speed of Rise
27 seconds (approx.)
Max. Load per Arm
2,500 lbs. (1134kg)
Ceiling Height Required
12'
(3658mm)
13' 9"
(4191mm)
14' 9"
(4496mm)

*Lift capacity ratings are based on loads equally distributed on all four arms.  1 Rise Height is measured with adjustable screw pads in highest position.  2 Specifications are listed with lift at maximum width and/or height settings.  3 Specifications are listed without rubber pad, for measurements with rubber pad add 1/4" (6mm).  4 Optional 3 phase electrical also available (Not available for Quick Cycle models). Specify at time of order.  Standard lift colors are Red and Blue. Optional colors available.
Optional frame engaging adapters (10314 or 10318) are REQUIRED when lifting vehicles with frame construction.


CL10 Two Post Lifts
Challenger Lifts on Facebook Follow Challenger Lifts on Twitter Challenger Pictures on Flickr Challenger Pictures on Flickr

Leading Car Lift Innovation for over 28 years