E10 Two Post Lift » Specifications

Model Number	E10	with E10EH2** column height extensions
Lift Capacity*	10,000 lbs. (4536kg)
A Rise Height¹	74-3/4" (1899mm)
B Overall Height	11' 11-7/8" (3655mm)	13' 11-7/8" (4265mm)
C Overall Width	10' 11-3/4" (3347mm)
D Drive-Thru Clearance	98-3/8" (2499mm))
E Floor to Overhead Switch	11' 5" (3482mm)	13' 5" (4092mm)
F Front Arm Reach	21-3/4" / 39-1/4" (553mm / 998mm)
G Rear Arm Reach	38-1/4" / 55-3/8" (971mm / 1407mm)
H Screw Pad Height²	4-1/4" / 6-3/4" (109mm / 199mm)
I Inside of Columns	110-1/4" (2800mm)
Motor	2HP, Single Phase, 60Hz
Voltage	208v - 230v
Speed of Rise	50 seconds
Max. Load per Arm	2,500 lbs. (1134kg)
Ceiling Height Required³	12' (3658mm)	14' (4268mm)
Shipping Weight	1750 lbs. (794 kg)	1950 lbs. (885 kg)

*Lift capacity ratings are based on loads equally distributed on all four arms. **Specifications are for Lift Model E10 with optional accessory E10EH2 column height extensions (Must order E10 and E10EH2 for new lift purchase or E10EH2 for addition of 2´ height extension to an existing lift). 1 Rise Height is measured with telescoping screw pads in highest position. 2 Specifications are listed without rubber pad, for measurements with rubber pad add 1/4" (6mm). 3 Ceiling Height requirement may exceed 12' if column shimming is necessary.
Optional frame engaging adapters (10314 or 10318) are REQUIRED when lifting vehicles with frame construction.

Find a Rep near you!

Outside the US? Click Here
Become a Distributor or Installer

Join our mailing list