Home >> Car Lifts >> Two Post Auto Lifts >> SA10 >> Specifications

SA10 Two Post Lift » Specifications


Model Number
SA10

Lift Configuration

Symmetric Configuration
Asymmetric Configuration

Lift Capacity*

10,000 lbs. (4536kg)
A Rise Height1
74-7/8" (1892mm)
B Overall Height
11' 4-1/2" / 11' 10-1/2" (3467mm / 3620mm)
C Overall Height (Cylinder Extended)
11' 10-1/2" (3620mm)
- with SA10EH2 2' height extension
13' 4-1/2" / 13' 10-1/2"(4077 / 4230mm)
D Overall Base Width
10' 9" / 11' 3" (2356mm / 2508mm)
10' 11-1/2" / 11' 5-1/2" (3340mm / 3493mm)
E Drive-Thru Clearance
92-3/4" / 98-3/4" (2356mm / 2508mm)
88-1/2" / 94-1/2" (2248mm / 2400mm)
F Floor to Overhead Swith
131-1/8" / 137-1/8" (3331mm / 2483mm)
G Short Arm Reach
22-3/8" - 41-1/2" (3331mm - 1054mm)
H Long Arm Reach2 (min/max)
38-1/4" - 59" (972mm - 1499mm)
I Screw Pad Height
4-5/8" - 6-7/8" (111mm - 165mm)
J Inside of Columns
106-3/4" / 112-3/4" (2711mm - 2864mm)
101-1/2" / 107-1/2" (2578mm - 2731mm)
Motor
2HP, Single Phase, 60Hz
Voltage
208v - 230v
Speed of Rise
48 seconds
Max. Load per Arm
2,500 lbs. (1134kg)
Ceiling Height Required
12 (3658mm)

*Lift capacity ratings are based on loads equally distributed on all four arms. 1 Rise Height is measured with telescoping screw pads in highest position. 2 Specifications are listed without rubber pad, for measurements with rubber pad add 1/4" (6mm) 3 Overall width of Asymmetric lift is 11' 3"' / 11' 9" including power unit
† Frame engaging adapters (10314 or 10318) are REQUIRED when lifting vehicles with frame construction


SA10 Two Post Lifts
Challenger Lifts on Facebook Follow Challenger Lifts on Twitter Challenger Pictures on Flickr Challenger Pictures on Flickr

Leading Car Lift Innovation for over 28 years