VS10 Two Post Lift » Specifications

Model Number	VS10
Lift Capacity*	10,000 lbs. (4536kg)
A Rise Height¹	76" (1930mm)
B Column Height (min/max)	11' 11-1/2" / 12' 5-1/2" (3645mm / 3797mm)
Cylinder Height at Full Rise	12' 1-3/8" (3693mm)
C Adj. Overall Width (min/max)	10' 11" / 11' 4-3/4" (3327mm / 3473mm)
D Drive-Thru Clearance (min/max)	92-3/8" / 98-3/8" (2346mm / 2499mm)
E Floor to Overhead Switch (min/max)	11' 6" / 12' (3505mm / 3658mm)
F Front Arm Reach (min/max)	22-1/8" / 41-1/2" (562mm / 1054mm)
G Rear Arm Reach (min/max)	38-5/8" / 61-3/8" (981mm / 1559mm)
H Screw Pad Height² (min/max)	3-7/8" / 7-1/8" (98mm / 181mm)
I Inside of Columns (min/max)	104-1/2" / 110-1/2" (2654mm / 2807mm)
Motor	2HP, Single Phase, 60Hz
Voltage	208v - 230v
Speed of Rise	52 seconds
Max. Load per Arm	2,500 lbs. (1134kg)
Ceiling Height Required³ (min / max)	12' 2" / 12' 6-1/2" (3708mm / 3823mm)
Shipping Weight	1850 lbs. (839 kg)

*Lift capacity ratings are based on loads equally distributed on all four arms. 1 Rise Height is measured with telescoping screw pads in highest position. 2 Specifications are listed without rubber pad, for measurements with rubber pad add 1/4" (6mm) 3 Ceiling Height required is 12′ 2" when lift column height is configured at minimum height and 12′ 6" when configured at maximum height.
Optional frame engaging adapters (10314 or 10318) are REQUIRED when lifting vehicles with frame construction.

Find a Rep near you!

Outside the US? Click Here
Become a Distributor or Installer

Join our mailing list