Pressroom

Press Releases

Two Post Model E10 Reduced Overall Height

Louisville, KY July 21, 2008 -

Challenger Lifts' 10,000 lb. capacity two post lift model E10 now features a reduced overall column height. At 11' 11-7/8" overall column height, E10 can now be installed in service facilities with lower ceiling heights. The ceiling height requirement3 is now 12'.

Additional specification changes:

Faster rise at 50 seconds (Floor to overhead switch 11' 5")
Rise height 75-3/4"

Adjustable screw pad height 4-1/4" min to 7-3/4" max with rubber pad and 4" min
to 7-1/2" max without rubber pad

Model Number	E10
Lift Capacity*	10,000 lbs. (4536kg)
A Rise Height¹	75-3/4" (1924mm)
B Column Height	11' 11-7/8" (3655mm)
C Overall Width	10' 11-3/4" (3347mm)
D Drive-Thru Clearance	98-3/8" (2499mm))
E Floor to Overhead Switch	11' 5" (3482mm)
F Front Arm Reach	21-3/4" / 39-1/4" (553mm / 998mm)
G Rear Arm Reach	38-1/4" / 55-3/8" (971mm / 1407mm)
H Screw Pad Height²	4" / 7-1/2" (103mm / 194mm)
I Inside of Columns	110-1/4" (2800mm)
Motor	2HP, Single Phase, 60Hz
Voltage	208v - 230v
Speed of Rise	50 seconds
Max. Load per Arm	2,500 lbs. (1134kg)
Ceiling Height Required³	12' (3658mm)

*Lift capacity ratings are based on loads equally distributed on all four arms.
1 Rise Height is measured with telescoping screw pads in highest position.
2 Specifications are listed without rubber pad, for measurements with rubber pad add 1/4" (6mm).
3 Ceiling Height requirement may exceed 12' if column shimming is necessary.

Find a Rep near you!

Outside the US? Click Here
Become a Distributor or Installer

Join our mailing list